LHI 1 to 6 1S Lipo Battery Parallel Charger Board XT60 Input with Dual BEC for Eachine E010 RC Drone Quad Helicopter Lipo Battery

This charger makes field charging your model plane, drone, or quadcopter easy! Just take any 3s or 4s lipo with an XT60 connector and plug it in to this charger and charge dozens of 1s packs. You could also use a wall adapter as supply power so you can continuously charge at home.

Once supplied with a 3s or 4s battery, just plug your 1s batteries into the charger to start charging. When you connect a discharged 1s battery to the charger the corresponding ports LED light will turn red until the battery is fully charged. Once charged, the LED will turn green and you can remove your 1s battery and fly!

Specifications:
Weight: 36g
Dimensions: 75x42x17mm
Input: 3s - 4s Selectable
Cutoff Voltage: 10.8v (3s), 14.4v (4s)
Output: Fixed at ~400 milliamps
4.20v cell charging cutoff (+- 0.5% margin of error)

Note:
Ports are numbered 1-6. Do not put more than one battery on a single port. For example: do not insert one battery on the Picoblade 1.25 plug and another on the same port with the PH 2.0 plug.

Package Included:
1 x 1S Lipo LiHV Charger Board

Charge 1S Lipo batteries (4.2V) and HV Lipo batteries (4.35V) at once in the same board by a selectable switch
Support charge up to 6 pcs batteries with Picoblade 1.25 or JST PH2.0 power plug at once
Turns itself off when supply battery reaches safe low-voltage，XT60 Input (3s or 4s) for field charging
2 channels BEC for supply current. 400mAh current per charge port
LED lights indicate when each battery is done charging
[amz_corss_sell asin="B074TDFVZL"]