QWinOut OPLINK MINI CC3D Universal Transceiver TX RX Module Integrating Remote Controller PPM Input DIY FPV Drone

[gallery]
Oplink Mini:
- 100mw Standalone Radio Modem
- 3 Io Ports: Micro-b USB, Mainport & Flexiport
- MMCX Antenna Connector.
- Weight: 4g
- Dimensions: 20mm x 29mm
- Input Voltage: +5v

Package Includes:
- OPLM Radio Transceiver x 1
- Nessary Cables x 1set
 
Summary: 
This Page Will Walk You Through How To Set Up The Hardware Connections That Are Required For Coptercontrol, Cc3d And Atom Oplink Operation. All Openpilot Boards Support Connection With The Oplink Module. The Oplink Connection Can Be Used For Telemetry And/Or Vehicle Control. 
The Oplink Module Will Get It's Power From The Flight Controller's External Power, So Unlike Revolution, The Modem Will Not Get Powered On By Just Plugging In The USB To The Flight Controller. Make Sure That You Have The Same Openpilot Firmware Versions On Both The Flight Controller And Oplink Modem. All The Examples Below Are Shown With a Cc3d Flight Controller Board, But They Can Be Applied To Coptercontrol And Atom, Also.
Hardware Connections
Telemetry Only
The Oplink Will Be Set Up to Talk Bidirectional Telemetry with The Flight Controller. You Can Use a Regular Openpilot 4-Pin JST SH Cable To Connect The Two Boards. It is Recommended To Use Main Port for Both Boards, But You Can Also Use Other Ports To Connect Telemetry. Just Remember The Changes In The Configuration Steps Below.
Open Source Flight Controller Does Not Provided One By One Full Technical Guidance
- 3 Io Ports: Micro-b USB, Mainport & Flexiport
The Oplink Module Will Get It's Power From The Flight Controller's External Power, So Unlike Revolution, The Modem Will Not Get Powered On By Just Plugging In The USB To The Flight Controller.
Make Sure That You Have The Same Openpilot Firmware Versions On Both The Flight Controller And Oplink Modem.
Package Includes: - OPLM Radio Transceiver x 1 - Nessary Cables x 1set
[amz_corss_sell asin="B0179M3NK0"]